Rack/Tower Online UPS NUPS 22-1000-3000 User Manual
7 Step 4 Step 5 Step 6 Remove the top cover of battery box and replace the inside batteries. After replacing the batteries, put the battery box
8 3-battery kit Step 1: Remove adhesive tapes. Step 2: Connect all battery terminals by following below chart. Step 3: Put assembled battery
9 Step 3: Put assembled battery packs on one side of plastic shells. Step 4: Cover the other side of plastic shell as below chart. Then, battery k
10 3. Operations 3-1. Button operation Button View Button Function ON/Mute Button Turn on the UPS: Press and hold ON/Mute button for at le
11 Display Function Backup time information Indicates the backup time in pie chart. Indicates the backup time in numbers. H: hours, M: minute
12 3-3. Audible Alarm Battery Mode Sounding every 4 seconds Low Battery Sounding every second Overload Sounding twice every second Fault Continuous
13 3-5. UPS Setting There are two parameters to set up the UPS. Parameter 1: It’s for program alternatives. There are 9 programs to set up: Pa
14 04: ECO enable/disable Interface Setting ENA: ECO mode enable DIS: ECO mode disable 05: AECO enable/disable Interface Setting ENA: Advance
15 08: Programmable outlets setting Interface Setting 0-999: setting the backup time limits in minutes from 0-999 for programmable outlets which
16 3-6. Operating Mode Description Operating mode Description LCD display Rack Display Tower Display Online mode When the input voltage is within ac
Uninterruptible Power Supply System Version: 1.2
17 Standby mode UPS is powered off without output power, but the battery still can be charged. Fault mode The UPS is in fault mode when no output
18 4. Troubleshooting If the UPS system does not operate correctly, please solve the problem by using the table below. Symptom Possible cause Reme
19 Symptom Possible cause Remedy Fault code is shown as 43 and The icon is lighting on LCD display and alarm is continuously sounding. The UPS shut
20 5. Storage and Maintenance 5-1. Operation The UPS system contains no user-serviceable parts. If the battery service life (3~5 years at 25°C amb
21 MODEL 1000U 3000U Capacity VA/W 1000 VA / 900 W 3000 VA / 2700 W INPUT Voltage Range Low Line Transfer 80 VAC/70 VAC/60 VAC/55 VAC ± 5
Table of Contents 1. Important Safety Warning ... 1 1-1. Transportation ...
1 1. Important Safety Warning Please comply with all warnings and operating instructions in this manual strictly. Save this manual properly and read
2 1-5. Maintenance, service and faults The UPS system operates with hazardous voltages. Repairs may be carried out only by qualified maintenance p
3 2. Installation and setup NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. Please keep the
4 Remove front panel. Connect the AC input and re-connect battery wires. Put the front panel back to the unit. This UPS can be either displayed
5 Tower Installation Step 1 Step 2 Step 3 2-3. Setup the UPS Step 1: UPS input connection Plug the UPS into a two-pole, three-wire, grounded rece
6 Step 5: Disable and enable EPO function Keep the pin 1 and pin 2 closed for UPS normal operation. To activate EPO function, cut the wire between pi
Comments to this Manuals